Televes QPSK-PAL CI Manual De Instrucciones página 40

User manual
b.- Input menu
This menu displays the following input para-
meters: input frequency (950-2150 MHz),
input PQSK baud rate (2 - 42.5 Mbaud) and
LNB power supply (0V, 13V, 17V and 22KHz
tone).
To modify a parameter you must press
until the desired parameter flashes on and
off. Then you can change the value using
and
.
INPUT
F:1802 MHz
27.500 Kbaud
LNB:13v22KHz
Should a shortcut is detected in the input
connector (LNB powering enabled), the front
led of the module will blink until this state
disappears.
All manuals and user guides at all-guides.com
c.- Service menu
The name of the selected service is displa-
yed along with the number of available ser-
vices in the multiplex.
SERVICE
1/5
TVE 1
By pressing and
change the selected service.
40
STEREO QPSK-PAL CI
d.- Audio menu
There are two different modes for the selec-
tion of the audio service: language search
and index. (see point 5.2.b Audio Mode Menu
in the EXTENDED MENU)
In audio for language you can choose two
favourite languages for the audio. The unit
will search for the audio correspondent to
the first selected language. If it doesn't find
buttons you can
it it will search for the second favourite. If it
can't find any of the favourite languages the
unit will select the first audio service of the
program.
In this mode the unit searches for the selec-
ted audio even when this language is broad-
casted in one of the channels of a dual ser-
vice.
The list of languages that can be selected is:
AUDIO
Audio 1: fin
Audio 2: den
Stereo