Cable Clamping; Caution In Installing Multiple Recorders In An Eia Rack - Mitsubishi Electric DX-NV100E Manual De Instalación Y Funcionamiento

Connections (continued)
1 Insert the supplied clamp band into the clamp hole
Step
on the rear of the recorder.
The clamp hole is for the power cable.
•
2 Run the cable to be clamped around the clamp
Step
band as shown in the fi gure.
The rough side of the band should face up.
•
Follow the steps below to install the recorder in an EIA rack (occupying 2U space) using the rack mount adaptor (DX-RM3).
1 Remove the feet from the bottom of the recorder. (4 feet)
2 Fit the rack mount adaptor using the screws on both sides of the recorder. (2 screws on each side)
3 Secure the recorder to the EIA rack using screws.
Prepare appropriate screws for your rack.
14
All manuals and user guides at all-guides.com

Cable clamping

Caution in installing multiple recorders in an EIA rack

3 Pull the end of the clamp band until it is tightened.
Step
Rack mount adaptor (DX-RM3)
Screws on the recorder (2 screws on each side)
Feet on the bottom of the recorder (4 feet)