Troubleshooting; Illumination Status Of Indicators; Checking The Status Of The Recorder - Mitsubishi Electric DX-NV100E Manual De Instalación Y Funcionamiento

Troubleshooting

The indicators on the front panel of the recorder blinks or illuminates, showing the condition of the recorder as shown in the table
below.
HDD operation Mirroring
mode
Spanning
Error
Error after Normal (no error)
startup
LAN LINK error
Error
Camera No camera connected
connection
Connection error
Camera connected
Self test Executing
Error detected
No error detected
Error during HDD recognition error
startup
Error occurred or no response returned during
reading-out of the management information
Not formatted
: The indicator goes out.
: The indicator illuminates.
: The indicator blinks.
This recorder uses many electronic parts and HDDs and malfunction may occur in them. By checking the status of the recorder
(faulty or normal) using the self test function, you can fi nd a malfunction, if any, at an early stage and prevent the recorder from
remaining faulty.
1 Press the SELF TEST button on the front panel of the recorder.
Step
The indicator on the button blinks during self test. It illuminates when no error is detected.
When the indicator goes out, the error is detected. Consult your dealer.
18
All manuals and user guides at all-guides.com

Illumination status of indicators

Checking the status of the recorder

ALARM
POWER REC ALERT IP-CAM MIRRORING
REC
Green Red Red Amber
<Self test function>
SELF
TEST
Green Green Green