Sauder 410147 Instrucciones De Montaje página 15

Step 10
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (I) and lay it over your unit.
Make equal margins along all four edges of the BACK (I).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (I) to your unit using the NAILS (FF).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHTS (C and D).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
www.sauder.com/services
These holes must line up over the UPRIGHTS (C and D).
I
410147
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
FF
NAIL
(38 used in this step)
Page 15