18 VOLT CULTIVATOR TINE SET
AC04142
WARNING:
To reduce the risk of injury, user must read and understand
the operator's manual for their product and this instruction
sheet. Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Ensure compatibility and fit before
using this accessory. Do not use this accessory if a part is
damaged or missing. If you are not comfortable performing
any of the functions described in these instructions, take your
unit to an authorized service center.
CALIFORNIA PROPOSITION 65
WARNING:
This product and substances that may become airborne from
its use may contain chemicals, including lead, known to the
State of California to cause cancer, birth defects, or other
reproductive harm. Wash hands after handling.
PACKING LIST:
4 in. Tines (2)
Hitch Pins (2)
The following instructions apply only to the Ryobi P2700 18
Volt Cultivator.
INSTALLING NEW TINES
See Figures 1 - 2.
WARNING:
To prevent accidental starting that could cause serious per-
sonal injury, always remove the battery pack from the product
when assembling parts.
Remove the battery pack.
Using pliers, remove the old hitch pins and old tines from the
cultivator's motor head.
With a clean dry cloth, remove any dirt or debris from around
the motor head and studs.
Fit the new tines onto the studs of the motor head so that the
studs go through the holes of the tines.
NOTE: Be sure the flat sides of the studs are aligned with the
flat side of the holes of the tines.
To secure new tines in place, insert the new hitch pins into
the holes located on either side of the studs so that the small
rounded section of the hitch pin fits over the stud.
RYOBI is a registered trademark of Ryobi Limited and is used pursuant to a
license granted by Ryobi Limited.
All manuals and user guides at all-guides.com
Fig. 1
A - Motor head (moteur de tête, motor de cabeza)
B - Stud (goujon, vástago)
C - Tines (lames, púas)
D - Hitch pin (goupille de sûreté, pasador del enganche)
Fig. 2
A - Stud (goujon, vástago)
B - Hitch pin (goupille de sûreté, pasador del enganche)
A subsidiary of Techtronic Industries Co., Ltd. • OTC: TTNDY
A
D
TECHTRONIC INDUSTRIES
NORTH AMERICA, INC.
1428 Pearman Dairy Road, Anderson, SC 29625 USA
1-800-860-4050 • www.ryobitools.com
B
C
A
B
990000890
1-8-14 (REV:01)