Removing The Cover; Additional Information - Fisher-Price Safe Voyage Grow-With-Me FP3000 Manual Del Usuario

FC5823W-ICA 21/12/09
Before removing the cover it is necessary to remove the backrest from the base.
If doing so with the harness on the seat is best to loosen or remove the harness.
(see 'removing the harness').
To remove the backrest, rest you weight on the base. Now grip the backrest sides and pull
hard upwards until you hear and feel a click. The backrest should now rotate backwards (32).
The base should now separate.
To reassemble, you will find two projecting tabs at the base end of the backrest.
Align and engage both tabs with the openings found at the rear of the seat base (36), and
then raise the back up vertically (37) as the tabs insert into the openings.
When raising the backrest to vertical, ensure that no parts of the harness, cover, etc can be
trapped between the backrest and the seat base.
Once the back rest is fully vertical, pull the backrest forward whilst at the same time pressing
firmly downwards by pushing on the top of the backrest until you hear and feel a click, make
sure the tabs are full inserted into the openings and the back rest feels secure and stable (38).
Dismantle the harness before beginning operations to remove the cover (see 'removing the
harness').
Unhook the backrest cover elastic strap and slide off the cover then pull the headrest cover
off and unhook the elastic hooks from the diagonal belt guides (33).
Slide the seat cover over the armrests and off the front of the booster seat (34).
This car seat is not approved for use on aircraft. For more information contact the airline.
To dispose of your car seat safely always remove the harness and render the seat unusable.
This car seat is a "Universal" child restraint system. It has been approved in accordance
with regulation N°44/04, and is suitable for general use in vehicles and is compatible with
the majority of vehicle seats.
This child restraint is likely to fit if the vehicle manufacturer states that the vehicle
approval specifies suitability for "Universal" child restraint systems.
This restraint system is classified as "Universal" in accordance with the strictest
approval criteria, whereas earlier models do not correspond to these new provisions.
It can only be installed in vehicles with 3-point static or retractable seat belts that
have been approved compliant with the UN/ECE N° 16 or other equivalent standards.
If in doubt, contact the manufacturer or retailer of the restraint system.
12:02 Page 10
All manuals and user guides at all-guides.com

Removing the Cover

Additional Information

NOTICE
10