Connecting Gas Circuit To Lpg Cylinder - BUTSIR ATRIO Manual De Instrucciones

Instruction for connecting gas circuit to LPG cylinder:
Keep at hand suitable crossed screwdriver, adjustable spanners, pliers and wrenches. Before assembly,
make sure all protection packing material has been removed. Flexible gas hose(1763-1) and clamps (if
necessary) are supplied with this appliance and must be used, according to National Rules in force. You
need to purchase one gas regulator and one gas cylinder. The gas regulator has to be set according to
specific gas category (see on data plate) and proper gas consumption (g/h) specification. The LPG cylinder
should be the Butsir Pro.
Recommend to use 5 kg. Replacement must be that specified in "Gas Requirements" section of this In-
struction Manual. Be careful: do not kink flexible gas rubber pipe of gas circuit. If pipe holder should not be
provided, thread of the gas inlet connection will be in line with Standards ISO 7-1 or ISO 228-1, according
to National Rules in force of the country of destination.
Make sure appliance gas knob is turned "OFF" (full disk) before assembling (see below Figure 5).
●
Put the LPG cylinder inside of the tank bracket,and tight the screw(see below Figure 6-7)
●
5
Connect the regulator to LPG cylinder by
●
hand. And Hand tighten only.(see below
Figure 7)
Connect the hose to the appliance and the
●
regulator. Tighten the screw of the hose
clamp with a screwdriver.(see below Figure
8)
24
Manual ATRIO.indd 24
6
7
8
30/4/21 13:29