DJI OM Guía De Usuario página 3

EN
Disclaimer and Warning
Congratulations on purchasing your new DJI OSMO
this entire document and all safe and lawful practices DJI OSMO provided
carefully before use. Failure to read and follow instructions and warnings
may result in serious injury to yourself or others, damage to your DJI OSMO
product, or damage to other objects in the vicinity. By using this product,
you hereby signify that you have read this document carefully and that you
understand and agree to abide by all terms and conditions of this document
and all relevant documents of this product. You agree to use this product only
for purposes that are proper. You agree that you are solely responsible for
your own conduct while using this product, and for any consequences thereof.
DJI OSMO accepts no liability for damage, injury or any legal responsibility
incurred directly or indirectly from the use of this product.
OSMO is a trademark of SZ OSMO TECHNOLOGY CO., LTD. (abbreviated
as "DJI OSMO") and its affiliated companies. Names of products, brands,
etc., appearing in this document are trademarks or registered trademarks
of their respective owner companies. This product and document are
copyrighted by DJI OSMO with all rights reserved. No part of this product or
document shall be reproduced in any form without the prior written consent
or authorization of DJI OSMO.
This document and all other collateral documents are subject to change at
the sole discretion of DJI OSMO. For up to date product information, visit
http://www.dji.com and click on the product page for this product.
This document is available in various languages. In the event of divergence
among different versions, the English version shall prevail.
Requirements
1. Only attach the Magnetic Ring Holder to phones that are supported by DJI
OM 4. Refer to the DJI OM 4 Mobile Phone Compatibility List at www.dji.
com/om-4 for more information.
2. The sticker must be used when attaching the Magnetic Ring Holder to a
phone made of glass. DO NOT attach the Magnetic Ring Holder directly to
a phone that made of glass.
3. DO NOT attach the Magnetic Ring Holder to a phone case. Otherwise, the
gimbal performance may be affected.
Attaching the Magnetic Ring Holder
1. Use the wet wipes to clean the back of the phone and then use the dry
wipes to dry. Attach the sticker to the center of the back of the phone.
2. Place the Alignment Guide on the back of the phone. Adjust the position of
the Alignment Guide to locate the center of the phone.
3. Attach the Magnetic Ring Holder to the back of the phone. Make sure it is
firmly attached.
4. Remove the Alignment Guide. Wait 12 hours before attaching the phone to
DJI OM 4 with the Magnetic Ring Holder.
Magnetic Ring
Holder
Sticker
Phone made
of glass
TM product. Please read
Phone case
Magnetic Ring
Holder
2