Countertop Requirements; Power Requirements - Bosch NEB 36 Manual De Instrucciones

Countertop
Requirements
Installing Over an Oven

Power Requirements

All manuals and user guides at all-guides.com
No. 28 MSG sheet steel, 0.015-inch (0.4 mm) thick stainless steel, 0.024-inch (0.6
mm) aluminum, or 0.020-inch (0.5 mm) thick copper. Flame retardant materials
bear the mark:
UNDERWRITERS LABORATORIES INC.
SURFACE BURNING CHARACTERISTICS
Followed by the flame spread and smoke ratings, these designations are shown
as "FHC (Flame Spread) / (Smoke Developed)". Materials with "O" flame spread
ratings are flame retardant. Local codes may allow other flame spread ratings.
The minimum horizontal clearance from the sides and back edge of the cooktop to
the adjacent vertical combustible walls is 0 (zero) inches.
Countertop cutout dimensions are shown in the figure and table below. A range of
cutout dimensions is shown because the actual dimensions depend upon whether
the installation is for replacement, new construction, or installation in a solid sur-
face countertop material, such as Surel™ or Corian®.
Solid surface countertops require larger cutouts, use of heat reflective tape and
rounded corners. Always consult the countertop manufacturer for specific installa-
tion instructions. For solid surface countertop installations, use the maximum cut-
out dimensions below and consult the surface manufacturer for specific cutting
instructions.
30" (76.2 cm)
Minumum
A
2-1/2"
(63,8 mm)
Setback Distance
(
from front edge of counter-
top to front edge of cutout.)
Table 1: Standard Countertop Cutout Dimensions
Cutout Minimum Dimension
Area inches / (mm)
A 2 1/2" (63.5 mm) setback
B 19 7/8" / (505 mm)
C 34 3/4" / (883 mm)
This unit is not approved for installation over an oven.
Power Supply is dual rated: 240 Volts or 208 Volts, 4 wire, 60 Hz, with the follow-
ing circuit breaker requirements:
CLASSIFIED
MINERAL AND FIBER BOARDS
1" (25.4 mm) Flat Area
B
C
1" (25.4 mm)
Flat Area
Figure 2: Countertop Requirements
Maximum Dimension
2 1/2" (63.5 mm) setback
distance
1-3/4" (44.5 mm) Flat Area
1" (25.4 mm) Flat Area
inches / (mm)
distance
20" / (508 mm)
34 7/8" / (886 mm)
English 3