Replacing The Door Spring; Replacing The Heating Elements; Instructions For Ordering Spare Parts - GGM gastro PDP44TC Manual Del Usuario

Replacing the door spring

To replace the door spring, firstly follow the instructions provided in the previous chapter (Replacing the door glass)
to remove the door from the oven, and then separate the inner door.
•
Once the inner door has been removed, remove the circlip that locks the spring pin (figure on the left);
•
Remove the pin in order to be able to remove the spring;
•
Replace the spring and reposition the pin with the locking circlip (figure on the right);
•
Carry out the steps in reverse order to reassemble the door.

Replacing the heating elements

Once the "Safety precautions" have been carried out, replace the heating elements as follows:
•
Remove the right side panel to replace the top's heating elements;
•
Disconnect the power supply wires for the heating elements being replaced;
•
Move the mineral wool aside to access the fixing screws or nuts of the heating elements being replaced;
•
Remove the faulty heating element and replace it with the new one;
•
Carry out the steps in reverse order for the reassembly.
•
Remove the right side panel to replace the bottom's heating elements;
•
Disconnect the power supply wires for the heating elements being replaced;
•
Move the mineral wool aside to access the fixing screws or nuts of the heating elements being replaced;
•
Remove the bottom's hollow tiles;
•
Remove the faulty heating element and replace it with the new one;
•
Reposition the hollow tiles and carry out the steps in reverse order for the reassembly.

Instructions for ordering spare parts

To order spare parts, the following information must be provided, which can be found on the silver plate located on the right
side of the oven:
•
Oven model;
•
Oven serial number;
•
Component code (see the spare parts list);
•
Quantity required.
61