Replacement Parts; Additional Information - Uline H-86 Manual De Instrucciones

MODEL
REPAIR KIT
REPLACING TEFLON ROLL
1. Turn off power and unplug sealer.
2. Remove pressing plate and loosen teflon clips.
(See Figure 6)
3. Cut off a new section of teflon tape. Replace
pressing plate and tape.
• Always keep the sealing platform clean. Remove
any residue (typically overheated plastic) from the
teflon barrier tape.
• Clean the sealing platform with a dry cloth. Do not
use water or solvents.
• A short circuit will occur if the bottom teflon tape
strip wears out. Each time you replace the heating
element or the top teflon tape, check the bottom
teflon tape for wear or damage.
• Only use Uline replacement parts.
• A worn rubber pressure pad (under the handle) will
influence the quality of the seal. The rubber pad
should be periodically checked for uneven wear.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 4 OF 12

REPLACEMENT PARTS

H-86 H-87 H-89
H-204 H-173 H-174
Figure 6
Pressing
Plate
Teflon
Clips

ADDITIONAL INFORMATION

4. Adjust teflon screw to tighten teflon roll. (See Figure 7)
5. Tighten teflon clips.
Pressing
REPLACING HEATING ELEMENT
1. Turn off power and unplug sealer. Release teflon clips.
2. Remove screws to release heating element.
3. Remove old heating element and replace with the
new one.
4. Reattach and tighten the teflon tape.
• Potential risks of fire, electric shock, or injury to
persons are capable of occurring due to use of the
product. User is cautioned to place the product so it
is not likely that the product will be overturned.
• Eliminate the potential risks of electric shock during
the replacement of a lamp or cleaning of the
product by disconnecting the power supply cord.
• Close supervision is required when this product is
used near children.
1-800-295-5510
uline.com
Heating
Teflon
Element
Tape
Teflon
Screw
Plate
Teflon
Clip
Figure 7
0620 IH-86