Publicidad
Idiomas disponibles
Idiomas disponibles
Important! The fitting must be installed,
flushed and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer
in position on the basin.
3. Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation
valves; cold right - hot left.
5. 33004XXX: Connect the pull rod to the pop-
up waste.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 12 l/min 3 bars
Operating pressure:
Recommended operating pressure: 1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
6
English
7 l/min 3 bars
max. 10 bars
16 bars
max. 80° C
65° C
If the continuous water heater causes any pro-
blems or there is not enough flow of water, the
waterdimmer (6a) located behind the aerator must
be removed.
To adjust the hot water limiter on single lever
mixers, please see page 13.
No adjustment is necessary when using a conti-
nuous flow water heater.
Spare parts (see page 3)
1
handle
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
locking screw for handle
6
aerator cpl. (10)
7
pull rod
8
fixing set
Special accessories
X
special tool set
(order as an extra)
33091000
94191000
94192000
94194000
92730000
96059000
13912000
92620000
96016000
58085000
Publicidad
