Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose and
threaded base and tighten the collar nut by hand.
If there is not enough space, please use only the
slide washer and the metall without the plastic
washer.
4. Tighten screws.
5. Connect the connecting hose to the angle valves;
cold right - hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
Operating pressure:
Recommended operating pressure:1 - 5 bars
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Single lever mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 1.5
bars.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
6
English
max. 10 bars
16 bars
max. 80° C
65° C
11 l/min 3 bars
Spare parts (see page 3)
1
lever head
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
aerator cpl. (10)
6
fixation cpl.
7
connection hose 600 mm
14092000
96338000
96391000
94194000
92730000
13955000
95049000
96556000
Publicidad
