Settings Menu; Grinding Blade Replacement; Adjusting Grinding; Using The Scales - Fiorenzato XGR Manual De Instrucciones

light up.Use the buttons C1 and C2 to move
through the menu and change the setting.
Use the button M to select and confirm. Exit
the menu after confirming by pressing the
button M.
• Language: English, Italiano, Español,
Français, Deutsch, Português, Chinese,
Russian, Korean, Malaysian, Thai, Greek.
• Time: set time.
• Time Layout: 12 or 24 hours.
• Date: set date.
• Temperature: Centigrade or Fahrenheit.
• Brightness: adjustment in percentages.
• Information: Firmware version and Serial
Number.

SETTINGS MENU

To access the SETTINGS menu, keep the but-
ton C1 pressed until an intermittent sound
starts (about 5 secs.). Three yellow buttons
will light up.Use the buttons C1 and C2 to
move through the menu and change the set-
ting. Use the button M to select and confirm.
Exit the menu after confirming by pressing
the button M.
• GRINDING WEIGHTS: single and double
dose weight adjustment.
• CALIBRATION: dose setting.
• SCALES: free weight system.
• GRINDING BLADE REPLACEMENT: hours.
• GRINDING BLADE RESET: reset mills timer.
• FACTORY RESET: restore factory settings.
• STATISTICS: show statistics.
• MANUAL GRINDING: activate manual
grinding button M.
• GRINDING MODE: Standard, Automatic,
PRE/SEL e Direct.
When the grinding blades need to be re-
placed, a warning appears on the display. The
state of wear can be monitored by accessing
the SETTINGS menu and selecting GRINDING
BLADE REPLACEMENT.
After replacing the grinding blades, the re-
placement timer needs to be reset. To do this,
access the SETTINGS menu, select GRINDING
BLADE RESET and confirm the reset.

ADJUSTING GRINDING

In order to achieve finer or coarser grind-
ing and therefore vary the granulometry,
use the adjustment disk located under the
hopper.
To increase the coarseness of the ground
coffee, the adjustment disk must be rotated
clockwise, pressing the adjustment disk lock
downwards, to decrease turn the disk anti-
clockwise. When the coffee grinder is
switched on, as indicated in the paragraphs
WARNINGS FOR INSTALLATION AND ELEC-
TRICAL CONNECTION and OPERATING THE
GRINDER-DOSER,adjustment can be carried
out by pressing the button M (hand) on the
display, which starts the grinding, possibly
without coffee between the grinding blades.
It is advisable to grind small amounts of cof-
fee to facilitate a visual check of optimum
granulometry and, if required, adjust the
grinding adjustment disk. If the coffee comes
out of the espresso coffee machine very
quickly, it means that the coffee is ground
too coarse. Vice versa, if it comes out too
slowly, it means the coffee is ground too
fine. Nonetheless, bear in mind that there
are many conditions liable to influence the
correct supply, such as the weight of the
portions, the compacting, the espresso ma-
chine settings and the cleaning of the filters.

USING THE SCALES

After removing the coffee collection tray,
place the coffee collection container provid-
ed in its housing on the calibration plate, so
that the two parts correctly match up (see
Fig.2).
26