Signal Strength Indicator; Manual Time Setting; Alarm Time Setting - Bresser ClimaTemp TB Instrucciones De Uso

date are automatically synchronized with the time signal
transmitted from Europe. When used for the first time (after
inserting the batteries or pressing [ RESET ] key), the clock
will start to receive the RC signal in 5 minutes with the signal
strength indicator flashing.

SIGNAL STRENGTH INDICATOR

The signal indicator displays signal strength in 4 levels. Wave
segment flashing means time signals are being received. The
signal quality could be classified into four types:
Symbol
Signal no
strength signal
NOTE!
1. Everyday the unit will automatically search for the time signal
at 2:00am , 8:00am, 2:00pm and 8:00pm.
2. Always place the unit away from interfering sources such as
TV set, computer, etc.
3. Avoid placing the unit on or next to metal plate.
4. Closed area such as airport, basement, tower block or factory
is not recommended.
5. Do not start reception on a moving article such as vehicle
or train.
18
weak acceptable excellent
signal signal

MANUAL TIME SETTING

1. In normal time mode, press and hold [ TIME ] key for 2
seconds to enter the 12/24 h display setting.
2. Press [ UP ] or [ DOWN ] key to set the desired value.
3. Press [ TIME ] key again, Hour digit flashes. Press [ UP ] or [
DOWN ] key to change its value.
4. Repeat the above operation to set the time in this order: 12/24
h > Hours > Minutes > Seconds > Time zone +/- 23 hours >
Daylight savings auto/off
5. Press [ TIME ] key to save and exit the setting or let it exit
automatically 30 seconds later without pressing any key.

ALARM TIME SETTING

signal
1. In normal time mode, press and hold [ ALARM ] key for 2
seconds to enter alarm time setting mode. Hour digit flashes.
2. Press [ UP ] or [ DOWN ] key to change the value.
3. Press [ ALARM ] key again to change to minute digit.
4. Press [ UP ] or [ DOWN ] key to change the value.
5. Press [ ALARM ] key to save and exit the setting, or let it exit
automatically 30 seconds later without pressing any key.
ACTIVATING ALARM
In normal time mode press [ ALARM ] key twice in quick to
activate the alarm. LCD shows Alarm time mode and displays