Reception Of Radio Controlled Time Signal; Signal Strength Indicator - Bresser NATIONAL GEOGRAPHIC 9070400 Instrucciones De Uso

NOTE!
1. If no signals are received or the transmission is interfered, ‚---'
will appear on the LCD.
2. Position the receiver and transmitter within the effective
transmission range: 30m in usual circumstances.
3. If the device is running on battery power, only a minimum
power supply is guranteed. The display is working on lowest
level, projection and color change function are not available
in low battery mode.
Remote sensor
1. Open the battery compartment covering carefully.
2. Install 2 batteries (AA/LR6 size 1.5V) strictly according to the
polarities shown.
4. Reinsert the battery compartment door.
NOTE!
Once the channel is assigned to one transmitter, you can only
change it by removing the batteries or resetting the unit.
16

RECEPTION OF RADIO CONTROLLED TIME SIGNAL

The time and date are radio-controlled. The current time and
date are automatically synchronized with the time signal
transmitted from Europe. When used for the first time (after
inserting the batteries or pressing [ RESET ] key), the clock
will start to receive the RC signal in 5 minutes with the signal
strength indicator flashing.

SIGNAL STRENGTH INDICATOR

The signal indicator displays signal strength in 4 levels. Wave
segment flashing means time signals are being received. The
signal quality could be classified into four types:
Symbol
Signal no
strength signal
NOTE!
1. Everyday the unit will automatically search for the time signal
at 2:00am , 8:00am, 2:00pm and 8:00pm.
2. Always place the unit away from interfering sources such as
TV set, computer, etc.
3. Avoid placing the unit on or next to metal plate.
4. Closed area such as airport, basement, tower block or factory
accept-
weak excellent
able
signal
signal
signal