Worx WG268E Manual Original página 11

OPERATING INSTRUCTIONS
WARNING! DO NOT USE THE
PRODUCT WITHOUT ATTACHING
THE GUARD AND FRONT HANDLE.
INTENDED USE
This machine is intended to be used
domestically for cutting and trimming hedges
and bushes.
1. GUARD ASSEMBLY
Insert the Safety Guard (7) into the slot as
illustrated in Fig A; Use two screws to fix the
guard securely.
NOTE: Make sure the Guard is firmly secured
in place
2. FRONT HANDLE ASSEMBLY
The Front Handle (6) must be assembled
before use:
1) Remove the bolt from the Front Handle.
2) Attach the Front Handle to the housing.
Make sure the protruding marks on the
Front Handle fit perfectly into the matching
indentation on the housing. (See Fig. B&C)
3) Insert the locking bolt into the handle and
fully tighten the bolt. (See Fig. D)
4) Check whether handle is firmly secured, if
not retighten the locking bolt.
NOTE: Make sure the handle is firmly secured
in place
3. BEFORE USING YOUR CORDLESS
HEDGETRIMMER
WARNING! The charger and battery pack
are specially designed to work together
so do not attempt to use any other devices.
Never insert or allow metallic objects into your
charger or battery pack connections because
of an electrical failure and hazard will occur.
NOTE: Your battery pack is UNCHARGED and
you must charge once before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
4. CHARGING YOUR BATTERY PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
Cordless Hedge Trimmer
All manuals and user guides at all-guides.com
protective circuit.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
5. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. E)
Depress the Battery Pack Release Button (4) to
remove the Battery Pack (3) from your Hedge
Trimmer. After recharging, insert the Battery
Pack into trimmer's battery port (See Fig. E).
A simple push and slight pressure will be
sufficient until a click is heard. Check to see if
the battery is fully secured.
NOTE: When removing the battery pack, hold
it firmly to avoid dropping and injury.
6. BATTERY STATUS LED'S (See Fig. F )
NOTE: The Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
Press the button "POWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged, even
though the trimmer may still be capable
of trimming hedge. Continuing to operate
your trimmer with the battery in this
discharged condition may reduce the life
and performance of your battery.
7. STARTING AND STOPPING
BEFORE STARTING YOUR HEDGE
TRIMMER
Remove Blade Sheath (9).
TO START YOUR HEDGE TRIMMER
Your Hedge Trimmer is equipped with both
Rear and Front Switch levers. Both switch
levers need to be depressed for the Hedge
Trimmer to start. Depress and hold the Front
) are illuminated, the
) is illuminated,
EN
11