Kohler K-308 Guia De Instalacion página 6

1/2" Adapter or
Solder Direct
1/2"
Copper
or Pipe
1/2" Elbow
Hot Supply
Stem
Assembly
4. Finish the Valve Body Installation
CAUTION: Risk of product damage. The valve body contains
plastic components. Remove the stop nut and stem assembly,
valve cap, and pressure balancing unit before you apply
soldering heat to the valve body.
Connect the water supplies to the valve body using elbows, 1/2"
copper tubing or pipe, and adapters (if needed). Use thread
sealant on all threaded connections.
IMPORTANT! Secure the piping to the framing.
Temporarily install 1/2" nipples to the bath and shower elbows
so they will extend at least 2" (5.1 cm) beyond the finished wall.
If you removed the inner valve components for soldering,
carefully reinstall them now.
088841-2-AC
Temporary
Nipple
Valve Body
Cold
Supply
Spacer
Collar
Screws
Stop Valve
Nut
Cap
Temporary
Nipple
6 Kohler Co.