SCHÜTTE Cesari Instrucciones De Montaje página 107

or
Buttock shower / lady shower
The water pressure is too low.
The water temperature is too
low.
The water temperature is too
high.
The water jet suddenly
interrupts.
Water drips from the retract-
ed shower arm.
Connect to hot water pipe.
Warm air dyer
No function.
Temperature of the hot air
dryer is too cold.
Temperature of the hot air
dryer is too hot.
Odour extraction
No or reduced function.
Odour extraction makes
unusual noises.
* Setting instructions: 1 = Low level — 5 = High level
Please check
The water lter in the hose
connection is dirty.
The water inlet hos.e is
kinked.
The water temperature is set
to level 0 or 1*.
The water temperature is set
to level 5*.
The shower function switch-
es o automatically after 3
minutes.
The shower arm is automat-
ically cleaned before and
after use.
Check if the hot water pipe is
connected.
The user was not detected
by the seat sensor.
The water temperature is set
to level 1.*
The water temperature is set
to level 5.*
Activated carbon lter is
blocked.
Activated carbon lter is
blocked.
Troubleshooting
Clean the water lter.
Remove the kink in the water
hose.
Please contact customer
service.
Set the water temperature to
level 2, 3, 4 or 5*.
Set the water temperature to
level 1, 2, 3 or 4*.
Normal function, no trouble-
shooting necessary.
Normal function, no trouble-
shooting necessary.
Must be connected to cold
water supply.
Change your sitting position.
Set the water temperature to
level 2, 3, 4 or 5*.
Set the water temperature to
level 1, 2, 3 or 4*.
Replace the activated carbon
lter.
Replace the activated carbon
lter.