Intended Use; Safety Advice - SCHÜTTE Cesari Instrucciones De Montaje

Model:
Voltage:
Power frequency:
Power consumption:
Power consumption (standby): <1 W
Protection method:
Protection class:
GB
Dear customer, you have purchased a product
of high quality and long service life from our
range. Please read this manual completely before
installation and follow the instructions. Please keep
the manual in a safe place and pass it on to any
subsequent owners. These installation instructions
can also be requested from our customer support
as a PDF le.

Intended use

The shower WC is only suitable for indoor use. The
shower WC can be used for cleaning the anal area
and for external cleaning of the vaginal area. It
is intended exclusively for private use and is not
suitable for commercial use. Only use the shower
WC as described in this operating manual. Any
other use is considered improper and may result
in damage to property or even personal injury. The
manufacturer or dealer does not accept any liability
for damage caused by improper or incorrect use.

Safety advice

HINT:
The following symbol
quali ed electrician is required!
•
electrical installation or excessive voltage can
lead to an electric shock!
• CAUTION ELECTRIC SHOCK! Before drilling,
make sure that there are no electrical cables in
Shower toilet and around the drilling location!
CAUTION! If the electrical connection is per-
(Cesari) •
92100 manently installed, work necessary for this and
230 V AC the connection to the power supply may only be
50 Hz carried out by a quali ed electrician! Repair work
1200 W on the electrical system of the shower WC may
only be carried out by a quali ed electrician or an
IPX4 authorised service employee after consultation
I with the manufacturer!
• Connect the shower WC only if the voltage of the
socket corresponds to the information provided
on the rating plate.
• Connect the shower WC to a socket outlet only
with at least 25 cm clearance from the ground.
• CAUTION WATER DAMAGE! Please switch o
the general water supply before installation.
• Incorrectly installed shower WCs may cause
water damage!
• CAUTION WATER DAMAGE! Before drilling,
make sure that there are no water mains at and
around the drilling location!
• Please have the installation carried out by only a
quali ed plumber.
• CAUTION for hot water setting: Risk of scalding!
• Only approved for mains or potable water. Do not
use seawater, service water or rain water.
• Only use a cold water supply! Connecting the ap-
pliance to a hot water supply may cause scalding
and damage to the appliance.
• The shower WC is only suitable for use in rooms
with a temperature above 0 °C. If there is a risk of
frost, interrupt the water supply and empty the
shower WC.
• Do not twist the connection hose or tension it!
tes that a • Do not operate the shower WC if there is visible
damage or if the power cord or plug is defective.
If the power cord of the shower WC is damaged,
Incorrect please contact the manufacturer immediately. It
must then be replaced by the manufacturer or
their customer service to avoid any hazards.