Kohler K-702300 Guia De Instalacion página 8

7A
Column
Groove
7C
Side
Panel
Door
Framework
8. Install the Door Framework
NOTE: For the sake of clarity, not all pieces are shown in 7A, 7B, 7C and 7D.
Place the door framework between the side panels and align the flange lip and strike post lip with
the column grooves as shown in 7A and 7B above.
Push the lips of the flange and the strike post all the way into the column grooves as shown in 7C
and 7D above.
NOTE: Do not overtighten the screws. Tighten by hand using a #2 Phillips screwdriver.
Secure the door framework to the side panels by attaching #8 x 5/8" flathead screws into the screw
ports of the column.
9. Install the Bushings and Plugs
If the door pivots on the right side, insert a bushing into the right side hole of the top and bottom
bridge member. If the door pivots on the left side, insert a bushing into the left hole of the top and
bottom bridge members.
Insert a plug into the opposite hole of the top and bottom bridge members.
1032629-2-B
Strike
Flange
Post Lip
Lip
Screwport
No. 8 x 5/8"
Flathead Screw
Side
Panel
Bushings go on pivot side, plugs go on open
side of the door. Left side pivot is shown.
7B
Column
Groove
7D
Plug
Bushing
Bridge Member
8
Bridge
Member
Bushing
Plug
Plug
Bushing
Kohler Co.