Technoline WS6441 Manual De Instrucciones página 13

Note:

Without pressing any button within 10 seconds, the station will automatically exit the setting
mode, the set value will be saved and the station will return to time display mode
Alarm and snooze function

Default alarm time is 7:00 A.M.

Alarm tone sounds when alarm time is reached during active alarm.

The alarm lasts 2 minutes and increases in intensity during the active alarm sound.

The bell symbol will be flashing during the active alarm sound.
1. Press the SNZ/LIGHT (17) button during the active alarm sound to pause the alarm and enter the
snooze mode; after 10 minutes the alarm will sound and the bell icon will flash again.
2. Whether in alarm mode or in snooze mode, press any key except SNZ/LIGHT (17) to exit alarm or
snooze mode and return to normal time mode.
3. If the SNZ/LIGHT (17) button is used during snooze mode, its original function will not change.
Backlight function
While using only batteries: press the SNZ/LIGHT (17) button to activate backlight for 10 seconds.
While using power adapter: plug in the power adaptor to automatically switch to highest brightness
level, press SNZ/LIGHT (17) button again to switch the backlight brightness:
HI (high)  LO (low)  OFF 

Battery end indicator
Indoor low voltage: when detect to high level, there is no low voltage; when detect to low level, there is
low voltage, low level symbol appear (9)
Outdoor low voltage: according to the transmitter signal if there is low voltage the (6)
displayed. 
Weather forecast
The station predicts weather condition for the next 12 – 24 hours based on the change of atmospheric
pressure. The weather forecast is based on atmospheric pressure change and is about 70-75%
correct.4 kinds of graphics:
sunny
Atmospheric pressure unit is HPA or INHG. When setting the time, you can choose the measuring
unit.
The station automatically detects the atmospheric pressure changes accordingly to display the symbol
to forecast weather (1). This forecast concerns the 12/24 hours.
For example: If the station detects high atmospheric pressure, the display will show the symbol of the
sun, but externally it could rain, because the provision relates to the 12/24 hours.
Note: The weather forecast symbols may not reflect current weather conditions.
They relate only to future conditions. Predictions cannot be 100% secure due to various factors.
The manufacturer is not liable for any damages or situations caused b y an incorrect forecast.
Important placement guidelines
To ensure accurate temperature measurement, place units out of direct sunlight and away from any
heat sources or vents. Place the transmitter away from rainfall.
Display unit and outdoor sensor must be within 99ft (30m) of each other.
partly sunny
EN5
cloudy
icon is
rainy