Special Accessories - Hansgrohe Talis E2 31616000 Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Attention! The fitting must be installed, flushed and

tested after the valid norms.

Assembly

1. Flush through the supply pipes.

2. Place the mixer including the sealing washer in

position on the basin.

3. Slip the fixation piece including the washer over

the threaded pin and tighten the nut.

4. If necessary shorten platic hose according to the

table and insert it up to the collar into the shorter

blue marked copper pipe.

5. Connect the shorter, blue marked supply pipe

to the angle valve.

Connect the longer blue marked pipe to the inlet

and the red marked to the outlet of the storage

tank.

6. Connect the pull rod to the pop-up waste.

Attention!*

With water heaters of 5 liters the flow rate at the

mixer should not exceed 5 l/min.

In this case the flow rate must be reduced at the

isolation valve.

Operation

The mixer is activated by lifting the lever handle.

Turning to the left = warmer water,

turning to the right = cooler water.

max. permissible water pres-

sure on the spot

in MPa

0,1 - 0,15

0,2 - 0,3

0,4 - 0,7

Hose lengths to be used

storage tank volume

8, 10 and 15 liters

without hose

hose to be shortened to 90 mm

If pressure greater than 0,5 MPa, fit pressure reducer.

English

When the storage tank is being heated, the spout

will drip.

When changing the spray former, it is imperative to

use one made for this type of mixer.

Technical Data

Operating pressure:

Recommended operating pressure: 0,1 - 0,5 MPa

Test pressure:

(1 MPa = 10 bar = 147 PSI)

Hot water temperature:

Recommended hot water temp.:

Rate of flow with water heaters

of 5 liters:

Spare parts (see page 3)

handle

1.1 screw cover

flange

nut

cartridge cpl.

spray former

pop up rod

fixing set