Spare Parts; Special Accessories - Hansgrohe Metris 31200000 Manual Del Usuario

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the bidet.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the angle valves;
cold right - hot left.
5. 31200000 / 31202000 Connect the pull rod to
the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 8a) located behind the mousseur must
be removed.
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a
continuous flow water heater.
6
English

Spare parts

1
1.1screw cover
2
3
4
5
6
7
8
9
10
11

Special accessories

X
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
lever head
flange
nut
service set
seals
mixer ball
mixing unit cpl.
aerator cpl.
pull rod
fixation cpl.
connection hose
special tool set
(not part of delivery)
31091000
94186000
94130000
94106000
13952000
13962000
13964000
14095000
13912000
92620000
94138000
94076000
58085000