Installation; Right Place For Installation; Attaching The Plastic Wedges - Beko BFBF2413SS Manual Del Usuario

3

Installation

3.1. Right place for installation

Contact the Authorized Service for
the product's installation. To ready
the product for installation, see the
information in the user guide and make
sure the electric and water utilities are
as required. If not, call an electrician
and plumber to arrange the utilities as
necessary.
WARNING:
B
assumes no responsibility for
any damage caused by the work
carried out by unauthorized
persons.
WARNING:
B
cable must be unplugged during
installation. Failure to do so may
result in death or serious injuries!
WARNING:
is too narrow for the product to
A
pass, remove the door and turn
the product sideways; if this does
not work, contact the authorized
service.
avoid vibration.
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
direct sunlight or keep in damp
environments.
circulation to function efficiently.
The manufacturer
The product's power
If the door span
8 /24 EN
alcove, remember to leave at least 5
cm distance between the product and
the ceiling and the walls.
environments with temperatures
below -5°C.

3.2. Attaching the plastic wedges

with the product to provide sufficient
space for air circulation between the
product and the wall.
1. To attach the wedges, remove
the screws on the product and use the
screws provided with the wedges.
2. Attach 2 plastic wedges on the
ventilation cover as shown in the figure.
Refrigerator / User Guide