Federal Signal Corporation AMR6-2570 Instrucciones De Instalación página 5

h. Replace the adjacent tile, connect the wiring to the speaker (see figures 1 and 2), and
secure the speaker using the adjustable "L' shaped clamps.
D. TESTING/OPERATING.
Under certain conditions these devices are capable of producing sounds loud enough to
cause hearing damage. Adequate hearing protection should be worn if standing within
close proximity to the device while testing. Recommendations in the OSHA Sound Level
Standard (29 CFR 1910) should not be exceeded.
1. After installation is complete, be sure to test the system to verify that each speaker operates
satisfactorily. If it is found that the volume is too low for its location, a higher wattage tap may be
selected. Carefully remove the speaker and move the receptacle to a higher wattage tap (see figures
1 and 2). Reinstall the speaker and retest.
2. Provide a copy of these instructions for the Safety Engineer, system operator(s) and
maintenance personnel.
E. MAINTENANCE.
If cleaning of the front face of this device is required, a mild soap solution is recommended as the
cleaning agent.
Although not advised, if painting/touch-up of the grille model's vinyl face is necessary, a
vinyl-based paint is required for coverage.
F. SERVICE.
Any maintenance must be performed by a trained electrician in accordance with NEC
guidelines and local codes.
Federal Signal will service your equipment or provide technical assistance with any problems
that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair, must be accompanied by a
Return Material Authorization. This R.M.A. can be obtained from the local Distributor or Manufac-
turer's Representative.
At this time a brief explanation of the service requested or the nature of the malfunction, should
be given.
Address all communications and shipments to:
Federal Signal Corporation
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
NOTE
-3-