Pontec PondoCompact 500i Instrucciones De Uso página 8

- EN -
- EN -
Translation of the original Operating Instructions
EN
WARNING
W A R N I N G
• This unit can be used by children aged 8 and above and by persons
with reduced physical, sensory or mental capabilities or lack of ex-
perience and knowledge if they are supervised or have been in-
structed on how to use the unit in a safe way and they understand
the hazards involved. Do not allow children to play with the unit. Only
allow children to carry out cleaning and user maintenance under su-
pervision.
• Ensure that the unit is fused for a rated fault current of max. 30 mA
by means of a fault current protection device.
• Only connect the unit if the electrical data of the unit and the power
supply correspond. The unit data is to be found on the unit type plate,
on the packaging or in this manual.
• Disconnect all electrical devices in the water from the power supply
before reaching into the water. Otherwise there is a risk of severe
injuries or death by electrocution.
• Only operate the unit if no persons are in the water.
• Do not use the unit if electrical cables or housings are damaged.
• A damaged connection cable cannot be replaced. Dispose of the
unit.
Safety information
Correct electrical installation
• Special regulations apply for electrical installation in outdoor spaces. Only a qualified electrician may perform the
electrical installation.
– The qualified electrician has the necessary professional training, knowledge and experience to perform electrical
installation in outdoor spaces. The electrician can detect potential dangers and knows how to adhere to regional
and national standards, regulations and directives.
– For your own safety, please consult a qualified electrician.
• For your own safety, please consult a qualified electrician.
• Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-proof).
• Protect the plug connection from moisture.
• Only plug the unit into a correctly installed outlet. Ensure that the unit is fused for a rated fault current of max. 30 mA
by means of a fault current protection device.
8