Backlighting Of The Tool; Check The Integrity Of The Downloaded Program (In The Event Of Problems); Check The Version Of The Downloaded Program - De Dietrich AD264 Manual Del Usuario

4.4 Backlighting of the tool

The programming tool has a backlighting function. To configure this
function, proceed as follows:
Connect the programming tool to the PC using the USB cable
or to the control panel using the 14-pin connection cable.
Press the key until LUM is displayed.

4.5 Check the integrity of the downloaded program (In the event of problems)

Connect the programming tool to the PC using the USB cable
or to the control panel using the 14-pin connection cable.
Press the key until VErIF is displayed.
Press the OK key.
The parameter VErIF on displays.

4.6 Check the version of the downloaded program

Connect the programming tool to the PC using the USB cable
or to the control panel using the 14-pin connection cable.
Press the key until VErSIon is displayed.
Press the OK key.
The version and type of the appliance are shown on the screen.
Press a key other than OK 2 time to exit this menu.
09/12/2014 - 300011650-02
Press the OK key.
Use the +/- keys to activate / deactivate the backlighting (LUM
on / LUM oFF)
Press the OK key.
Wait a few seconds.
The progress bar will show you the verification status.
Checking has been correctly completed.
The parameter VErIF ot displays.
Otherwise
downloaded faulty therefore reload the compatible binary file.
Press a key other than OK 1 time to exit this menu.
Programming tool
is displayed:
VErIF Pb
Programme
19