Manuales relacionados para DJI FD1W4K
Resumen de contenidos para DJI FD1W4K
- Página 1 DJI FPV (Aircraft model:FD1W4K, Goggles model:FGDB28, Remote controller model: FC7BGC) Quick Start Guide v1.0 ...
- Página 2 Introduction Aircraft 1. Propellers 10. Auxiliary Light 2. Motors 11. Intelligent Flight Battery 3. Front LEDs 12. Battery Buckles 4. Landing Gears (Built‐in antennas) 13. Power Button 5. Frame Arm Light 14. Battery Level LEDs 6. Aircraft Status Indicators 15. Battery Port 7. Gimbal and Camera 16. Forward Vison System 8. Downward Vision System 17. USB‐C Port 9. Infrared Sensing System 18. microSD Card Slot ...
- Página 3 Goggles Remote Controller 1. Power Button 2. Battery Level Indicator 3. Lanyard Attachment 4. Customizable Button 5. Control Sticks 6. USB‐C‐Port 7. Flight Pause Button 8. Gimbal Dial 9. Flight Mode Switch 10. Customizable Switch Take‐off/Landing Button (non‐M mode) Lock/Unlock Button (M mode) 11. Shutter/Record Button 12. Antennas ...
- Página 4 Preparing the Aircraft Preparing the Goggles ...
- Página 5 PowerSupply...
- Página 6 Charging Checking Battery Levels and Powering On/Off Pressoncetocheckthebatterylevel. Press,thenpressandholdtoturnon/off. Linking ...
- Página 7 1) Press the link button on the goggles. 2) Press and hold the power button of the aircraft. 3) The battery level indicator of the aircraft turns solid and display the battery level, the goggles stop beeping when successfully linked and the video display is normal. 1) Press and hold the power button of the aircraft. 2) Press and hold the power button of the remote controller. 3) Both the battery level indicators turn solid and displaythe battery level, and the remote controller stop beeping when successfully linked. * When ready to link, the devices will give the following indication: Aircraft: the battery level indicator blinks in sequence Goggles: the goggles beep continually Remote controller: the remote controller beeps continually and the battery level indicator blinks in sequence Controls Goggles ...
- Página 8 Remote Controller Specifications Aircraft (Model: FD1W4K) Takeoff Weight 790 g Max Flight Time 20 mins Operating Temperature ‐10°to 40°C Operating Frequency 2.400‐2.4835 GHz, 5.725‐5.850 GHz Transmitter Power (EIRP) 2.4G: ≤30 dBm (FCC), ≤20 dBm (CE/SRRC/MIC) 5.8G: ≤30 dBm (FCC/SRRC), ≤14 dBm (CE) Camera Sensor 1/2.3’’ CMOS, Effective Pixels: 12M Lens FOV: 150° 35mm Format Equivalent: 14.66 mm Aperture: f/2.86 Focus: 0.6 m to ∞ ISO 100‐3200 Electronic Shutter Speed 1/8000‐1/60 s Max Image Size 3840×2160 Video Resolution 4K: 3840×2160 50/60p FHD: 1920×1080 50/60/100/120/200p Intelligent Flight Battery Capacity 2000 mAh Voltage 22.2 V(standard) Type LiPo 6S Energy ...
- Página 9 Charging Temperature 5°to 40° C Max Charging Power 90 W Goggles (Model: FGDB28) Weight Approx. 420 g(headband and antennas included) Dimensions 184×122×110 mm(antennas excluded), 202×126×110 mm(antennas included) Screen Size 2 inch×2 Screen Resolution 1440×810 (Single Screen) Operating Frequency 2.400‐2.4835 GHz；5.725‐5.850 GHz Transmitter Power (EIRP) 2.4G: ≤30 dBm (FCC), ≤20 dBm (CE/SRRC/MIC) 5.8G: ≤30 dBm (FCC/SRRC), ≤14 dBm (CE) Live View Mode Low Latency Mode(810p 120fps), High Quality Mode (810p 60fps) Video Format MP4(Video format: H.264) Supported Video Play Format MP4，MOV，MKV (Video format: H.264; Audio format: AAC‐LC, AAC‐HE, AC‐3, MP3) Operating Temperature 0°to 40° C Power Input 11.1‐25.2 V Goggles Battery Capacity 2600 mAh Voltage 7.4 V(standard) Type Li‐ion 2S Energy 19.3 Wh ...
-
Página 10: Compliance Information
Compliance Information FCC ComplianceNotice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant ... - Página 11 第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更 頻率、加大功率或變更原設計之特性及功能。 第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應 改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射 頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。 EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of the Directive 2014/53/EU. A copy of the EU Declaration of Conformity is available online at www.dji.com/euro‐compliance EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany Declaración de cumplimiento UE: SZ DJI TECHNOLOGY CO., LTD. por la presente declara que este ...
- Página 12 DJI GmbH, Ind dustriestrasse e 12, 97618, N Niederlauer, Germany Declar ração de co onformidade da UE: A SZ DJI TECH HNOLOGY CO O., LTD. decl lara, através deste docum mento, que e este disposit tivo está em m conformida ade com os ...
- Página 13 is for f free. The ow wner of old ap ppliances is r responsible t to bring the a appliances to o these collect ting points o or to similar collection p points. With this little p ersonal effor rt, you contrib bute to recyc le valuable ra aw materials and the treat tment of toxi ic substances s. Umwe eltfreundliche e Entsorgung Elektro o‐Altgeräte d dürfen ...
- Página 14 Os apa arelhos elétri icos antigos n não podem s ser eliminado os juntament te com os mat teriais residu ais. Têm de s ser eliminado os separadam mente. A elim inação no po onto de recolh a público atr ravés de ent idades partic culares é gra tuita. É da re esponsabilida ade ...
- Página 15 RF Exposure Information SAR tests are conducted using standard operating positions accepted by the FCC/ ISEDC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. Before a new model device is a available for sale to the public, it must be tested and certified to the FCC/ ISEDC that it does not exceed the exposure limit established by the FCC/ ISEDC, Tests for each device are performed in positions and locations as required by the FCC/ ISEDC. For head/Extremity, this model device has been tested and meets the FCC / ISEDC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal. Non‐compliance with the above restrictions may result in violation of RF exposure guidelines. Les tests SAR sont effectués en utilisant des positions de fonctionnement standard acceptées par la FCC / ISEDC avec l'appareil transmettant à son niveau de puissance certifié le plus élevé dans toutes les bandes de fréquences testées, bien que le SAR soit déterminé au niveau de puissance ...