Boeco BBL Serie Manual De Instrucciones página 4

Installation Instructions
Your balance is designed to provide reliable weighing results
under normal ambient conditions. When choosing a location
to set up your balance, observe the following so that you will
be able to work with added speed and accuracy:
– Set up the balance on a stable, even surface
– Avoid placing the balance in close proximity to a heater or
otherwise exposing the balance to heat or direct sunlight
– Protect the balance from drafts that come from open
windows or doors
– Avoid exposing the balance to extreme vibrations during
weighing
– Protect the balance from aggressive chemical vapors
– Do not expose the balance to extreme moisture over long
periods
Conditioning the Balance:
Moisture in the air can condense on the surfaces of a cold
balance whenever it is brought into a substantially warmer
place. If you transfer the balance to a warmer area, make
sure to condition it for about 2 hours at room temperature,
leaving it unplugged from AC power.
Setting up the Balance
4
All manuals and user guides at all-guides.com
Balances with an Analytical Draft
Shield Chamber:
§ Place the components listed
below inside the chamber in
the order given:
– Shield plate
– Shield ring
– Pan support
– Weighing pan
Balances with a Glass
Draft Shield:
§ Place the components listed
below on the balance in the
order given:
– Shield ring – place it on the
balance so that the edge for
fitting the glass draft shield
faces upwards and turn it until
it is firmly in place.
– Pan support
– Weighing pan
– Glass draft shield
– Draft shield cover
Balances with a Round Weighing
Pan Ø 115 mm
§ Place the components
listed below on the balance
in the order given:
– Pan support
– Weighing pan
Balances with a Round Weighing
Pan Ø 150 mm
§ Place the weighing pan
on the balance
Connecting the Balance to AC Power/Safety Precautions
Use only original AC adapters:
– for Europe: 6971948
– for the US:
– for the RSA: 6971949
– for Australia: 6971950
§ Insert the right-angle plug into
§ The AC adapter rated to
The ground is connected to the balance housing, which can
be additionally grounded for operation.
Using a (Rechargeable) Battery
(not for models BBL31, BBL32, BBL42 or BBL52)
$ Battery is not included with
!
!
§ Lay the balance on its side
§ Open the battery compart-
§ Insert the 9-volt
$ Make sure to connect
!
§ Close the battery compart-
6971947
the jack
Class 2 can be plugged into
any wall outlet without
requiring any additional safety
precautions
the equipment supplied
Use only a commercially
available (rechargeable)
9-volt battery
When using a rechargeable
battery, always use an
external recharging device
to recharge the battery
ment: Lift the compartment
cover
(rechargeable) battery in
the compartment
the positive and negative
poles correctly
All used batteries are
classified as waste that
requires special handling
(not "household" waste).
Dispose of rechargeable
batteries in accordance with
the applicable special waste
disposal regulations.
ment: Press down on the
cover until it clicks into place