Troubleshooting - Vitrifrigo SCP Manual De Instalación, Uso Y Asistencia

10

Troubleshooting

The following table serves to provide some suggestions concerning the checks to be made in case of
incorrect refrigerator operation.
If, after completing the suggested checks, the refrigerator is still not operating regularly, contact your
nearest assistance service.
Problem
The refrigerator will not start
The refrigerator is noisy
The cooling power of the
refrigerator is not sufficient
022129 BA BKE SCP EN, DE, FR, ES, IT V01
Possible cause Solution
Power supply Make sure that the power cord is correctly plugged into the power socket
Make sure the main power switch is on "I" position
Make sure that the automatic breaker on the system's electrical panel is on
Make sure that the plug socket is working
Make sure that the power cord is not damaged and/or broken
Thermostat Make sure that the digital thermostat is set to ON
Position Make sure that the refrigerator has been properly levelled
Make sure that the refrigerator is not in contact with furniture or other items
that might increase its vibrations
Refrigerant pipes Make sure that the pipes and/or components of the refrigerant circuit are not
touching. This is a check that must only be carried out by a specialist service
technician
Door closure Make sure that the door is correctly closed and also that the gasket is not
damaged in any point
Position Make sure that the refrigerator is not too close to heat source
Condenser Make sure that the refrigerator is positioned so that the condensation air can
be discharged correctly (from the rear panel)
Make sure that the condenser fan is rotating correctly
Check the condenser for dust and clean if necessary
Defrosting Make sure that the insides of the refrigerator are not excessively covered in
ice. Defrost if necessary
EN
Seite 13 von 72