Fuse Replacement - TechGrow Clima MicroPlus Manual Del Usuario

The values have been reset. The main screen appears
after a few seconds.
Secondly, by completing the following steps:
1. The main screen is displayed:
Temp 26c
Set 25c
2. Put a precision screwdriver (or paper clip) in the
small round hole on the back of the Clima Micro
Plus Temp/Humidity Fan Control and press one
time. The next screen appears:
Min/Max
Reset
The values have been reset. The main screen
appears after a few seconds.

5. Fuse replacement

If a short circuit occurs due to fan overload, the fuse will
blow. Even if the Clima Micro Plus Temp/Humidity Fan
Control does not operate at all, in the worst case, this
could indicate a blown fuse. To replace the fuse you
have to open the Clima Micro Plus Temp/Humidity Fan
Control. Complete the following steps:
1. Remove the plug from the socket.
2. Open the housing by unscrewing the 4 screws on
the back of the Clima Micro Plus Temp/Humidity
Fan Control.
3. Locate the fuse and remove it.
4. Insert a new 5 amp fuse.
5. Screw the 4 screws to close the housing.
Your Clima Micro Plus Temp/Humidity Fan Control is
ready for use again.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions 14