Thunderbolt™ Software - Toshiba Thunderbolt 3 Dock Manual Del Usuario

Thunderbolt™ Software
The Thunderbolt™ Software enables you to manage the dock.
1. After successfully connecting the dock to your computer, you will be
prompted that "New Thunderbolt™ devices have been attached".
Follow the on-screen instructions to enable Thunderbolt™ Software.
2. Launch the Thunderbolt™ Software by right-clicking the icon in the
system tray to configure the settings as desired.
■
■
■
Thunderbolt™ Networking is only available while there is a peer-to-peer
NOTE
connection between the computers.
■
User's Manual
View Attached Devices
It allows you to view all Thunderbolt™ devices attached to the
computer. Users can check the device information, connection
status and power mode here. You can also open Approve
Thunderbolt™ Devices by clicking the Connected or Not
connected button.
Approve Attached Devices
It allows you to select the device approve status. This item also
pops up when new devices are plugged in.
Do Not The device is not allowed to be connected or to
Connect work. Approve Thunderbolt™ Devices window
does not show when devices are connectd and
will pop up again when devices are re-plugged in.
Connect Only The device is allowed to be connected this time,
Once and need to be approved again the next time it is
plugged in.
Always The device is allowed to be connected always.
Connect
Thunderbolt™ Networking
It allows you to select the device approve status (actions the same
as Approve Attached Devices).
Manage Approved Devices
It shows the status/information of the approved devices. You can
choose to remove the selected devices or all.
Toshiba Thunderbolt™ 3 Dock
EN-19