General Maintenance; Maintenance; Nozzle Maintenance - Husky HU80215 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USiNG ThE CLEANiNG DECK
See Figure 14.
 Start the pressure washer.
 Walk slowly behind the cleaning deck, cleaning as you
go.
NOTE: If striping or swirling occurs, slow your pace.
If problem continues, see Troubleshooting later in this
manual.
CAUTiON:
Striking any raised obstacle which using with the clean-
ing deck will damage the unit. If contact does occur and
causes vibration when operating the pressure washer,
stop and replace the spray bar. Continuing to operate
the unit without replacing the spray bar could result in
serious injury or damage to the unit.
NOTE: See figure 15 for the location of the spray bar.
wARNiNG:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
wARNiNG:
Always wear eye protection marked to comply with
ANSI Z87.1. Failure to do so could result in objects be-
ing thrown into your eyes, resulting in possible serious
injury.
wARNiNG:
Before inspecting, cleaning or servicing the machine, shut
off engine, wait for all moving parts to stop, and discon-
nect spark plug wire and move it away from spark plug.
Failure to follow these instructions can result in serious
personal injury or property damage.

GENERAL MAiNTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
All manuals and user guides at all-guides.com
OPERATiON
MOViNG ThE PRESSURE wAShER
To move the pressure washer:
 Turn the pressure washer off. Point nozzle in a safe direc-
 Store the spray wand in the cleaning deck.
 Tilt the machine toward you until it balances on the wheels

MAiNTENANCE

Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an authorized service center.

NOZZLE MAiNTENANCE

Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or
dirty nozzle.
 Unplug the pressure washer.
 Turn off the pressure washer and shut off the water
 Remove the nozzle from the spray wand.
 Using a straightened paper clip or nozzle cleaning tool
 Using a garden hose, flush debris out of nozzle by back
 Reconnect the nozzle to the spray wand.
 Turn on the water supply.
Page 13 — English
tion and pull trigger to release water pressure.
then roll the machine to the desired position.
wARNiNG:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
supply. Pull trigger to release water pressure.
NOTE: Never point the spray wand at your face.
(not provided), free any foreign materials clogging or
restricting the nozzle.
flushing (running the water through the nozzle backwards
or from the outside to the inside).

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido