Operation - Husky HU80215 Manual Del Operador

CONNECTiNG ThE hiGh PRESSURE hOSE TO
ThE PUMP
See Figure 5.
 Insert the nipple on the end of the high pressure hose
collar into the pump outlet coupler.
 Slide the collar over the coupler turning the collar clock-
wise to tighten securely.
 Pull on the hose to be certain it is properly secured.
ASSEMBLiNG ThE SPRAY wAND
See Figure 6.
 Insert the end of the spray wand into the trigger handle
outlet coupler.
 Turn the connector clockwise until it stops. This secures
the wand in place.
USiNG ThE SPRAY wAND AS A hANDLE
See Figure 7.
When not in use, the spray wand can be stored in the cleaning
deck. In this position, the wand is then used as a handle to
push/move the pressure washer from place to place.
wARNiNG:
Do not allow familiarity with the product to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
wARNiNG:
Always wear eye protection marked to comply with
ANSI Z87.1. Failure to do so could result in objects be-
ing thrown into your eyes, resulting in possible serious
injury.
wARNiNG:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
wARNiNG:
Never direct a water stream toward people or pets, or
any electrical device. Failure to heed this warning could
result in serious injury.
All manuals and user guides at all-guides.com
ASSEMBLY
Attaching the spray wand to the cleaning deck:
 Assemble the trigger handle and spray wand as described
 Insert spray wand quick connect coupler into the clean-
CONNECTiNG hiGh PRESSURE hOSE TO
TRiGGER hANDLE
See Figure 8.
 Insert the
 Slide the collar over the coupler turning the collar clock-
 Pull on the hose to be certain it is properly secured.

OPERATiON

APPLiCATiONS
You may use this product for the purposes listed below:
 Using cleaning deck: removing dirt and mold from decks
 Using spray wand: cleaning cars, boats, motorcycles,
ADDiNG DETERGENT TO ThE PRESSURE
wAShER
See Figure 9.
Use only detergents designed for pressure washers; house-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage
the pump. Many detergents may require mixing prior to use.
Prepare cleaning solution as instructed on the solution bottle.
 Disconnect pressure washer from power supply.
 Place pressure washer upright on a flat surface.
 Remove cap from detergent tank.
 Pour detergent into tank until it reaches the maximum fill
 Reinstall cap.
Page 11 — English
previously in this manual.
ing deck inlet plug. Tilt upward until coupler clips into
position.
wARNiNG:
To reduce the risk of injection or injury, only use the
cleaning deck on flat, horizontal surfaces. Never lift the
cleaning deck from the cleaning surface while operating
the pressure washer.
nipple on the end of the high pressure hose
collar into the handle inlet coupler.
wise to tighten securely.
and cement patios
outdoor furniture, grills, and house siding
level located on the unit.
NOTE: Use a funnel, if needed, to prevent accidental
spilling of the detergent outside the tank. If any detergent
is spilled during the filling process, make sure the unit is
cleaned and dried before proceeding.