Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ES
7
STEP
7-1. Remove the 4 burner screws.
7-2. Insert the gas hose into the post.
7-3. Secure the burner unit to the post with
the 4 bolts.
7-4. Check if the vertical post connection and
the burner have been assembled according
to the instructions, and all bolts and nuts are
tightened.
STEP 8
WHEEL ASSEMBLY
Use 2 M8X15mm screws and
M8 nuts to connect the
bracket with castors to the base
Then fasten them.
1a. M8X15mm bolt
1b. M8 nut
1c. bracket with wheels
9
STEP
9-1. Raise the tank housing up and support it
on the post plate.
9-2. Connect the end thread of the inlet gas
hose to the regulator.
9-3. Connect the regulator to the gas tank and
tighten it with the adjustable spanner.
9-4. Place the LPG tank on the bracket.
9-5. Secure the canister with the propane tank strap.
7
Nilo
PASO 4
STEP 7
Perno
PASO 5
STEP 8
1a.
1b.
1c.
PASO 6
Tuerca de
Mariposa
STEP 9
STEP 9
PASO 7
Regulator
Gas tank
Regulador
Tanque gas
Publicidad
Tabla de contenido
