Gas Requirements; Leakage Test - Mobiclinic Nilo Instrucciones

Nilo
EN ES
Heater stand and location
• Always maintain proper clearance to combusti-
ble materials, i.e. top 100 cm and sides 100 cm minimum.
• Heater must be placed on level firm ground.
• Never operate heater in an explosive atmosphere like
in areas where gasoline or other flammable liquids or
vapors are stored.
• To protect heater from strong wind, anchor the base
securely to the ground with screws.

Gas requirements

• Use propane or butane gas only.
• The pressure regulator and hose assembly to be used must conform to local
standard codes.
• The installation must conform to local codes, or in the absence of local codes,
with the standard for the storage and handling of liquid petroleum gases.
• A dented, rusted or damaged propane tank may be hazardous and should be
checked by your tank supplier. Never use a propane tank with a damaged valve
connection.
• The propane tank must be arranged to provide for vapor withdrawal from the
operating cylinder.
• Never connect an unregulated propane tank to the heater.

Leakage test

• Gas connections on the heater are leak tested at the factory prior to shipment.
A complete gas tightness check must be performed at the installation site due
to possible mishandling in shipment or excessive pressure being applied to the
heater.
• Make a soap solution of one part liquid detergent and one part water. The soap
solution can be applie with a spray bottle, brush or rag. Soap bubbles will appear
in case of a leak. Do not perform with an open flame.
• The heater must be checked with a full cylinder.
• Make sure the safety control valve is in the OFF position.
• Turn the gas supply ON.
• In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn
the gas supply on and recheck.
• Never leak test while smoking.
11