Mobiclinic Nilo Instrucciones página 21

EN ES
Operation and storage
To turn on the heater:
1. Turn on the valve on the gas supply cylinder completely.
2. Press and turn the variable control knob to PILOT position (counter-clockwise
90º).
3. Press down the variable control knob and hold for 90 seconds. While holding
down the variable control knob, press the igniter button several times until the
pilot flame lights. Release the variable control knob after the pilot flame lights.
Note:
- If a new tank has just been connected, please allow at least one minute for the
air in the gas pipeline to purge out through the pilot hole.
- When lighting the pilot flame make sure that the variable control knob is
continuously pressed down while pressing the igniter button. Variable control
knob can be realeased after the pilot flame lights.
- Pilot flame can be watched and checked from the small round window with
sliding lid located at the bottom of the flame screen (to the left or right side of the
controller).
- If the pilot flame does not light or it goes out, repeat step 3.
4. After the pilot flame lights, turn the variable control knob to maximum position
and leave it there for 5 minutes or more before turning the knob to desired
temperatura position.
To turn off the heater:
1. Turn the variable control knob to PILOT position.
2. Press and turn the variable control knob to OFF position.
lgniter
Igniter
3. Turn off the valve on the gas supply cylinder completely.
Storage
1. Always close the gas valve of the gas cylinder ofter use or in case of disturbance
2. Remove the pressure controller and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect a damage,
have it changed by your gas dealer.
4. Always turn off the gas valve after use. If damage is suspected, bring it to the
attention of a qualified technician.
8
Variable control knob
Off: the heater stop work
Hi: maximum temperature position
Lo: minimum temperature position
Nilo