bloom Fresco Guia Del Usuario página 23

(#01 swivel shaft, #02 swivel shaft housing)
Insert the swivel shaft all the way into the swivel
shaft housing (make sure swivel resistor is
disengaged). Engage swivel resistor. (refer to
illustration a1)
Base & Seat Assembly
(#01 swivel shaft, #03 base, #02 swivel shaft
housing) Insert the swivel shaft to base by
aligning the 'unlock' icon marking on the base
to the indication line marked on the swivel shaft.
Turn until locked into position. You will hear an
audible click. In locked position the indication
line should point to the 'lock' icon. Check the
swivel shaft is securely locked by lifting upwards.
Press shaft button to raise swivel shaft.
To disassemble, lift the slide button on side of
swivel shaft whilst turning to align the 'unlock'
icon to indication line. Pull to remove.
(#04 seat unit) insert the seat unit onto swivel
shaft and tighten fastening cap counter-
clockwise. Check seat unit is secured by pulling
seat unit upwards. (refer to illustration a2)
Swivel & Height Adjustment
To rotate the seat unit, disengage the swivel/
height resistor, and then turn the seat unit
sideways to desired position.
To adjust seat height, disengage the swivel/
height resistor. Lift both A & B trigger
simultaneously, whilst pushing downwards or
pulling upwards to desired height, then release
the triggers. (refer to illustration a3)
IMPORTANT!
Ensure the seat unit is firmly inserted onto the
swivel shaft before use. Check the seat unit
is assembled properly by trying the height
adjustment function, following the instructions
in this user guide. If the height adjustment fails
to work, this means the seat unit is not properly
assembled, please re-try and press seat unit
downwards on the swivel shaft firmly in order
to properly engage the height adjustment
mechanisms.
Lift & Glide – Easy Glide Wheels
To move the baby chair across floor, first rotate
the seat unit so it is front facing, then engage
swivel resistor. Tilt the baby chair forward by
lifting in the handle area located on the rear
of the seat unit, and then glide the highchair
across floor using the castor wheels, which are
located under the front end of the base. (refer to
illustration a4)
WARNINGS:
• Continue to assemble the baby chair
according to the configuration suitable
for your child. Follow the corresponding
instructions carefully.
• A child's safety is your responsibility.
WARNINGS:
• Prevent serious injury or death from falls or
sliding out.
• Always secure child in the restraint.
• Never leave child unattended.
eng
3