Expansion Modules - Techem split 4.1.3 Manual De Operación

Expansion modules

• The calculator has a port for expansion modules.
• The modules have no retroactive effect on consumption recording and can be retrofitted
without damaging the calibration mark.
• The calculator incorporates automatic recognition and display of the module placed on
the ports.
• When radio and simultaneously M-Bus or M-Bus reading frequency are used for less
than 15 minutes, a power supply unit must be installed.
Installation of the modules
1 Release and remove the four Torx screws (T20) from the housing lid and remove the
cover.
2 Insert and engage the module via lugs. 
3 Remove the nipple from the corresponding cable entry grommets using a pair of
pliers.
4 Push the M-Bus or pulse cable through the entry grommet.
5 Place the cable in the strain relief and connect to the modules.
Close the cover and screw together (recommended tightening torque 1.8 Nm).
6
Press the push button to check the meter function.
7
!
The calculator recognises a new module after approx. 2 minutes at the latest.
Recognition takes place immediately when the button is pressed briefly, e.g. for
communication with new Techem software.
Attach the adhesive seal above the upper left-hand side screw to the upper part of the
8
calculator.
Installation of the power supply unit
Release and remove the four Torx screws (T20) from the housing lid and remove the
1
cover.
Place the power supply unit in the lower part of the calculator on the left-hand side.
2
6

3 Attach the connector plug to the connector PCB.
4 Guide the supply cable into the lower part of the calculator through the entry grommet
on the left-hand side.
5 Connect the supply cable to the supply terminals, place the terminal covers on them
and screw them down tight using screws.
6 Close the device cover and screw together (recommended tightening torque 1.8 Nm).
7 Attach the adhesive seal above the upper left-hand side screw to the upper part of the
calculator.
!
If a power supply unit is used, clamping may under no circumstances whatso-
ever be made between the two phases as this would destroy the power supply
unit. Touch protection can be installed at all times. The supply line must be
secured with a maximum of 6 A and against manipulation.
20
9