Techem split 4.1.3 Manual De Operación página 24

L2
Date (entry 2)
L3 Date (entry 3)
L4
Date (entry 4)
L5
Date (entry 5)
1 Only for calculators for heat or heat/cold
2 Only for calculators for cold or heat/cold
* Before the first due date: Production date or optional starting date
KT = Short button press < 3s
LT = Long button press ≥ 3s and < 10s
2s = No button press, automatic switching of the display after 2s
Configuration level - to set the variable device properties
- C4 – C5 "Place" - Installation location (
To set e.g. the inlet place of installation, the following procedure is required:
1 Change to the ribbon "Metrological configuration" (C0 – Config)
2 Press the button briefly until the C5 display appears.
3 Then, press the button longer until the display changes to "Set" .
4 Inlet has been set.
!
Observe the installation location for the temperature sensors or assemble pro-
gramming temperature sensors accordingly.
Please note:
If the button is not activated, the display jumps back to "C0 – Config" .
Restriction of parametrisation, see "Device properties" chapter.
24
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
• Unit
• Installation location
• Deletion of event log
• Decimal place
• Reset in production mode
• Setting of time
) - outlet/ - inlet)