Chef's Choice KTCC17MB13 Manual De Instrucciones página 6

• Avoid spilling water on the base unit. In the event the base unit becomes wet,
proceed as follows:
– disconnect the power cord from the power outlet.
– invert base unit and shake out all water.
– dry the base unit with a dry absorbent cloth.
– place the Kettle on the base and re-insert the power cord into the power outlet.
CAUTION: The Kettle always gets hot during operation. DO NOT touch the metal body
or lid. Lift the Kettle only by the handle and open the lid only by using the lid release
button or knob. Exercise care to avoid contact with steam or the water when opening
or closing the lid while the Kettle is still hot or contains hot water.
DRY-BOIL CUT-OUT
Your kettle is equipped with a boil-dry cut-out, which will switch off the kettle
automatically, should it accidentally be operated without water or by not observing
the minimum water level. In the event of such a safety cut-out, switch off the appliance
immediately, unplug it and let it cool down for approx. 10 minutes. Afterwards, your
kettle is ready for use again.
CARE AND MAINTENANCE OF YOUR
CHEF'SCHOICE
• The Chef'sChoice® Kettle is designed specifically for heating water. Do not attempt to
heat anything other than water in the Kettle. With liquids and mixtures of low water
content, the automatic steam activated shut-off switch may not function properly and
the Kettle may be damaged.
• Before cleaning, make sure power switch is turned "OFF", then remove the Kettle from
its base unit. Unplug the base unit.
• Always wait until the Kettle has fully cooled to room temperature before cleaning.
• To avoid scratching, clean the outside of the Kettle with a soft cloth only. Never use
abrasive cleanser.
• The interior of the Kettle can be cleaned by descaling at regular intervals
(see next page).
• Rinse out the Kettle at regular intervals and after extended non-use. Do not immerse.
• Do not attempt to clean any part of the Kettle or base in the dishwasher.
®
ELECTRIC KETTLE
English — 6