Sauder 409045 Manual De Instrucciones página 13

Step 9
Carefully stand your unit upright.
å
Separate the EXTENSION SLIDES (W) from the EXTENSION RAILS (V) as shown in the upper diagram.
å
Be prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (V) to the UPRIGHTS (C).Use four GOLD 5/16" FLAT HEAD SCREWS (QQ).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge of
å
the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
GOLD 5/16" FLAT HEAD SCREW
www.sauder.com/services
W
C
V
Open end
QQ
(4 used in this step)
V
V
C
409045 Page 13