Commissioning; Technical Data; Contact Allocation Table - Festo EduTrainer Universal Manual Del Usuario

7 19-inch module 8DOUT

7.2 Commissioning

1. Connect the inputs/outputs to the PLC using a flat cable:
– SV2: Siemens S7 (16-pin)
– SV1: Other controller types (10-pin)
2. If using modules in parallel, these can be connected via the free insulation-displacement connector SV1
or SV2 using flat cables.
3. Connect the 24 V power supply by means of the 3-pin connector SL1 or SL2.
4. The jumper JP1 is used to define whether the output module is supplied directly via 24 V or via 24 V NA.
24 V NA is switched off in the event of an EMERGENCY-STOP
(jumper between pins 1 and 2: supply via 24 V; jumper between pins 2 and 3: supply via 24 V NA).
5. Screw the 19-inch module into the frame.

7.3 Technical data

Operating voltage
Output current
Connection
Front-plate width
Subject to change

7.4 Contact allocation table

Pin SV1
1 L1+
2 Q0
3 Q1
4 Q2
5 Q3
6 Q4
7 Q5
8 Q6
58
All manuals and user guides at all-guides.com
SV2 Pin
0V 9
Q7 10
0V 11
Q6 12
0V 13
Q4 14
0V 15
Q4 16
24 V DC
Max. 0.5 A per output
4 mm safety sockets
6 modules
SV1 SV2
Q7 L1+
0V Q3
— L1+
— Q2
— L1+
— Q1
— L1+
— Q0
© Festo Didactic GmbH & Co. KG 739319