Base Station - Hama Color EWS-1400 Instrucciones De Uso

Note
• The wireless transmission range between the
measuring and base stations is up to 50 m in
open spaces.
• Before installation, ensure that wireless
transmission will not be disrupted by
interference or obstacles like buildings, trees,
vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there
is sufficient reception between the intended
installation locations.
• When installing the measuring station, ensure
that it is protected from direct sunlight and
rain.
• The international standard height for measuring
air temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material
from a specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are
installed.
• Never apply force during installation. This could
damage the product.
• Before installation, ensure that the chosen wall
is suitable for the weight to be mounted, and
make sure that there are no electrical wires,
water, gas or other lines at the installation site
on the wall.

5.1. Base station

• Use the base to position the base station on a
level surface.
• Alternatively, you can install the base station on a
wall using the opening (24) on the back.
All manuals and user guides at all-guides.com
5.2. Measuring station
• You can also position the measuring station on a
• We recommend installing the measuring station
• Install an anchor, screw, nail, etc. in the wall of
• Hang up the base/measuring station using the
6. Operation
6.1. Connection to the measuring station
• After you insert the batteries, the base station
• If the base station still does not receive a signal
level outdoor surface.
securely on an outdoor wall (29).
your choice.
opening (24/29) intended for this purpose.
Note
Hold down the + button (18) or the – button (19)
to select the values faster.
automatically searches for a connection to the
measuring station and performs initial setup.
Note
• Initial setup takes approx. 3 minutes.
• During connection, the wireless symbol on the
measuring station will flash (2).
• Do not press any buttons during setup.
Otherwise, values may not be transmitted
correctly and there is a risk of value errors and
inaccuracies.
• The setup process is completed when the
indoor (5/6) and outdoor (1/16) measurement
data is displayed
from the measuring station, press and hold the
SEARCH button (21) for approx. 3 seconds to start
the manual search for the signal.
5