Electrolux Clario Manual De Instrucciones página 8

1
4
8
12
8
2
5 6
9 10
13
English
G E T T I N G T H E B E S T R E S U L T S
Use the nozzles as follows:
Carpets:
position (1). Reduce suction power for small carpets.
Hard floors:
position (2).
3
Wooden floors:
Upholstered furniture:
in (4).
Curtains, lightweight fabrics, etc.:
shown in (4). Reduce suction power if necessary.
Frames, bookshelves, etc.:
shown in (5) or Easy clean (6 – certain models only).
Crevices, corners, etc.:
Using the power socket (requires a Clario equipped with a
designated power socket. The power nozzle is available as
an accessory.)
8 Attach the nozzle to the tube (certain models only).
9 Connect the power nozzle to the socket on the vacuum
cleaner.
10 Use the clips to secure the cable along the tubes and hose.
7
11 The power nozzle starts operating when the vacuum cleaner
is switched on.
Using the turbo nozzle (certain models only)
12 Attach the nozzle to the tube.
13 Adjust the suction power by opening or closing the air vent.
Note: Do not use the power or turbo nozzle on fur rugs, rugs with
long fringes or a pile depth exceeding 15 mm. To avoid damaging the
carpet, do not keep the nozzle stationary whilst the brush is rotating.
Do not pass the nozzle across electric cables, and be sure to switch off
the vacuum cleaner immediately after use.
11
Use the carpet/hard floor nozzle with the lever in
Use the carpet/hard floor nozzle with the lever in
Use the parquet nozzle (certain models only, 3).
Use the combination nozzle as shown
Use the combination nozzle as
Use the combination nozzle as
Use the crevice nozzle (7).