Activating The Sleep Function; Activating The "I Feel" Function; Setting The Time - Dometic B1600PLUS Instrucciones De Uso

B1600PLUS, B2200, B2600
9.11

Activating the sleep function

When the sleep function is active, the set temperature is reduced by 1 °C
after one hour and by 2 °C after two hours to generate a pleasant tempera-
ture for sleeping.
➤ Set the required temperature (see chapter "Setting the temperature" on
page 44).
➤ Press the SLEEP button.
✓ The
symbol appears in the display.
The sleep function is activated.
9.12

Activating the "I feel" function

When this function is active, the remote control measures the room tempera-
ture and transmits this measurement to the roof air conditioner every
10 minutes. The roof air conditioner adapts the target value to this measure-
ment.
➤ Press the I FEEL button.
➤ Position the remote control so that it points at the IR receiver (fig. 2
page 3) on the control panel. Otherwise, the values cannot be transmitted
to the roof air conditioner.
I
NOTE
The remote control should not be kept in a part of the room that is
considerably warmer or colder than the average room tempera-
ture. It may not, for example, be left in the sun or in front of the roof
air conditioner.
9.13

Setting the time

The remote control needs the current time in order to program the timer.
The time is indicated on the display of the remote control.
Perform the following steps to set the time:
I
NOTE
The remote control returns to its initial mode if no key is pressed
on the remote control for fifteen seconds while setting the time.
➤ Press and hold the CLOCK button to go to the mode used to set the time.
✓ The time flashes on the display of the remote control.
➤ Use the + or – button to set the current time.
➤ Press the SET button to confirm the time.
EN
Operating the roof air conditioner
4,
47