Uline ZEBRA GC420D Manual Del Usuario página 3

1. Open the printer and pull the media guides away
from each other. (See Figure 3)
NOTE: Open the media guides by turning the
media guide adjustment knob toward the rear
of the printer.
2. Place the media roll on the roll holders and release
the media guides.
3. Position the media roll so print side faces up as it
passes over the platen roller. (See Figure 3)
4. Pull the end of the media roll so it extends out of the
front of the printer. Ensure the roll turns freely.
(See Figure 4)
NOTE: The media roll should be supported by
the media guides and should not sit in the
bottom of the media compartment.
5. Push the media roll under the media guides.
(See Figure 4)
6. Close the media guides by turning the guide
adjuster knob to the front. They should just touch, but
not restrict the edges of the media.
7. Close the printer. Press down until the cover snaps
closed.
PAGE 3 OF 18
LOADING MEDIA ROLL
Figure 3
Figure 4
Figure 5
0518 IH-7245