Placing Tool In Service - Ingersoll Rand 7S30L–EU Iinstrucciones

LUBRICATION
Ingersoll–Rand No. 10
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
International – No. C18–C3–FKG0
After each eight hours of operation, replenish the oil
supply. Adequate lubrication is imperative for satisfactory
Gear life.
After each 50 000 cycles or each month, whichever
occurs first, inject approximately 6 cc of Ingersoll–Rand
No. 28 Grease into the Grease Fitting.
Sander Throttle
7S30L–EU + Lever
7S48L–EU Lever
7S60L–EU Lever
Polisher Throttle
7P24L–EU Lever
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 sanding on steel workpiece
+ Tested in accordance with PNEUROP PN8NTC1.2

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 28
SPECIFICATIONS
Free Speed Spindle and
Back Up Pad
rpm
3 000 5/8–11, 7"
4 800 5/8–11, 7"
6 000 5/8–11, 7"
Free Speed Spindle and
Back Up Pad
rpm
2 400 5/8–11, 7"
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
GSound Level
dB (A)
Pressure
89.5
81.4
82.0
GSound Level
dB (A)
Pressure
82.7
3
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
Level
Power m/s
102.5 1.7
– – – 0.9
– – – 0.9
♦Vibrations
Level
Power m/s
– – – 1.6
2
2