Horizontal Sliding Window Installation; Support Bracket; Washer; Nut - Friedrich SV08A10A Manual Del Usuario

Horizontal Sliding Window Installation

1. Loosely attach the Support Bracket to the
bottom of Bracket using Bolts, Washer, and
Nuts. Attach the Leveling Bolt and Nut. (Fig.
1)
2. Remove protective backing from Window
Track Seal and apply seal to window track.
(Fig.2)
3. Measure and lightly mark a line 8-1/4 inches
from window jamb. Center the Support
Bracket assembly on the window track and
fasten with 4 Type C screws.(Fig. 2)
4. Put the Support Bracket against the outside
wall and tighten the Bolts on top of the
Bracket. Adjust the Leveling Bolt so that the
air conditioner will be installed with a very
slight tilt (about 1/4") downward toward the
outside for proper drainage.
Tighten the nut. (Fig. 3)
NOTE!
DO NOT drill a hole in the bottom of the base
pan. The air conditioner is designed to operate
with the bottom of the base pan approximately
half-full of water.
5. Fasten Side Guides to the sides of the Air
Conditioner using 3 Type A screws per Guide.
Start with first screw at middle of Guide.
(Fig. 4)
6. Fasten Upper Guide on the top of the Air
Conditioner using 3 Type A screws. (Fig. 4)
All manuals and user guides at all-guides.com

Washer

Nut

Support Bracket

Window Jamb Window Jamb Windo
1 1
8 8 / / inches inches
4 4
Window Track Window Track Windo
Seal Seal
Windo Window Track Window Track
1 / "
About
4
Fastening Side Guides

Upper Guide

Te mp
er
atu re
Wa rm
er Me d
n Fa Of
f
Co ole
r
Hig
Co h
ol
Lo Fa w
n
Lo w
Co Me
ol Co d
ol
Mo
de
Installation

Bolt

Bracket

Leveling Bolt & Nut
Fig. 1
Type C screw Type C screw
Fig. 2
O u
t s i
d e
W a
Fig. 3
l l

Side Guide

Fig. 4
Owner's Manual 13